It can fit into a rack or a bench setup and integrate with COTS test equipment. This allows a repair technician to put the ARTES on a wheeled cart and bring it to his work station. If you could reduce your search time by quickly finding one ATE solution that Saves You Money, Saves You Time, and Saves You Space, what would that be worth to you?
Testing of combinational circuits is straightforward, but sequential circuits can be tested only if all feedback connections are broken. • Before starting any servicing work, check technical manuals and any leaflets for warnings and instructions regarding electrostatic damage precautions.
Poor Separation Of The Saw Blade From The Metal Stock
Use special controlled-impedance layout techniques to incorporate these transmission lines in the printed-circuit board. These lines require precisely calculated dimensions and are typically routed without vias. This simplified block diagram of the tester portion of the Figure 4 test system shows the custom hardware developed to test and compensate pressure sensors mated with MAX1457-MAX1459 signal-conditioning ICs. Having received commands from the PC via the serial bus, these microprocessors can perform relatively sophisticated control functions without the aid of the PC.
- Even with a huge discount the stuff was way expensive, like a couple thousand dollars for their small site.
- Accordingly, without payment or further consideration to you, you hereby assign to Ace all rights, including copyright and other intellectual property rights, in and to the Feedback.
- It is the job of a test technician to know which piece of test equipment to use for the task at hand and also understand the limitations of the test equipment they are using.
PIM is a particular issue when overlaying new carriers into old antenna runs. Table B-1 lists the basic tools and test equipment necessary to perform general maintenance and troubleshooting tasks on the Cisco uBR10012 router. Using IEEE 1588 precision time protocol, distributed LXI instruments on a network can be synchronized as closely as traditional backplane architectures, such as VXI and PXIe. The result is that synchronized instruments can be placed virtually anywhere without the constraints imposed by a physical rigid backplane and still offer superb performance.
MAPS The ultimate fully automatic preparation system, giving you excellent specimen quality, reproducibility and cost savings. LaboSystem A modular manual/semi-automatic grinding and polishing system with a choice of polishers, specimen movers and dosing units for the ultimate in adaptability. Mounting Accessories A wide selection of hot and cold mounting accessories, including cups, dyes, fixation clips, protection caps, engravers and AntiStik powder.
Safe Internet Filter By The Cleaner
In the video below, learn more about the cutter protection strip and keeping your blade holder clean. A burred edge is a common defect in the operation of a metal shearing machine. Often this is caused by improperly ‘gapped’ shear blades or blades that are just plain dull. Make sure you are consulting your metal shear manufacturers operational manual in order to set the proper clearance for your particular machine, material type and thickness. read more When diagnosing a machine that is not cutting straight look at the guides. If the rear guide is touching the blade even when not cutting, then the rear guide is probably set too far forwards.
Motor Circuit Analysis (MCA™) allows for deenergized motor testing of the entire electrical portion of the motor system. Our products in this category include our extremely popular ALL-TEST PRO 7™, ALL-TEST PRO 7™ PROFESSIONAL, ALL-TEST PRO 34™, ALL-TEST PRO 33 EV™ and MOTOR GENIE®. Identifying motor faults before the motor fails can save you countless hours in downtime and maintenance fees. Watch our video to learn more about the critical importance of motor testing. A mechanic who is trained in the operation, maintenance and CAT equipment repair is essential.